New or recently cleaned microfiber cover can be protected against dirt and stains with the microfiber Protector. It protects against accidents based on water, fat or oil, after which liquids can be swept away with a well-absorbing tissue. Microfiber Protector also restores the water-repellent properties of the coating.

The treatment does not change the appearance or feel.

This spray can is a protective device that is suitable for microfiber coating

Applications include:

Processing advice, microfibre Protector 500ml

Only apply to new or recently cleaned microfibres.
Substrate must be colourfast, first test a non-visible part. If the color gives off: DO NOT TREAT.

Hold the spray can upright and spray at approx. 20 - 25 cm. distance.
Spray in even lanes and let the treated surface dry for approximately 60 minutes. The maximum level of protection is reached after 6 to 12 hours! Check whether the treatment has been sufficiently applied by placing a few drops of water on the surface. The water droplets must "pearl".

If the drops of water sink into the coating within 5 seconds, repeat the treatment.
The capacity of the bus is sufficient for approx. 6 m². If a white substance remains after drying, brush it off (avoid extreme overdose). First remove deep stains with CleanTex stain spray.

After treatment:
Regularly check the treated microfiber and, if necessary, after treatment with a microfiber Protector, especially if the net has been cleaned intensively.